Create accountLogin

Recent searches

No recent searches

Search options

Only available when logged in.
mstdn.social is one of the many independent Mastodon servers you can use to participate in the fediverse.
A general-purpose Mastodon server with a 500 character limit. All languages are welcome.

Administered by:

Server stats:

13K
active users

mstdn.social: AboutStatusProfiles directoryPrivacy policy

Mastodon: AboutGet the appKeyboard shortcutsView source codev4.3.8

#enclosure

0 posts0 participants0 posts today
Continued thread
Public *
Athenenoctua

@_valerian_ Point commun au libre : le régime de propriété défini par une licence libre dont #Gnu, #Odbl, #creativecommoms

Les #communs : sous l'Ancien Régime, droits des communautés d'habitants de ramasser du bois mort, de faire paître les animaux, etc. Subsistance dans des usages aujourd'hui, comme l'affouage dans certaines #forêts communales (exemple personnel).

Fermeture des communs = #enclosure

Réflexions dans les années 1960 et 1970 sur ces #communs, comme Eline Ostrom.

#JdLL2025
Continued thread
Public
Fran 🇦🇷

Inside the case is a Heltec Wireless Stick Lite V3 board, with a 915 MHz antenna from Gizont and a 5V step-down regulator from Eletechsups.

The end of the power cable is sealed with solder, hot melt glue, and heat-shrink tubing to prevent the ingress of humid outside air due to the negative pressure caused by the thermal cycling of the case.

#MeshCore#Meshtastic#LoRa
Public
Fran 🇦🇷

Some photos of a waterproof enclosure I made to install a MeshCore or Meshtastic node on the roof.

It's made from standard heat-fused water pipes with UV protection on the outer layer. These pipes are polypropylene, and I can't measure any difference in RSSI when the node is installed inside.

#MeshCore#Meshtastic#LoRa
Public
Rommudoh

I recently rediscovered that I had a dual rail #powersupply in my stash that I intended to use for my #diysynth stuff. It takes AC input and outputs variable positive and negative DC voltages.
So, I built a nice #enclosure for it. It fits very tightly, but looks rather nice.
When testing it with my 12 Volt AC transformer, I could only get up to about +/-8 Volts. So, I need a bigger input voltage for my +/-12 Volt needs.
I use #GX16 for output and normal barrel jack for input.
#PSU #diy

a view into the enclosure. the main board is tugged into place. on the upper edge is the input barrel jack. bottom left and right are three GX16 connectors for the outputs. the cables are joined using WAGO connectors that are squeezed diagonally left and right for plus and minus output, and underneath the board for GND.
ExploreLive feeds
About